#Ccna 4 puzzle packet tracer activity code#
*NOTE: There was an error here (the middle code snippet line was not there previously), it has been fixed. So what we're going to do is start off with the blocking of the 10 assigned addresses, so enter the following: We have to configure R1 to act as a DHCP server for VLANs attached to S2, to which we must assign a name for each VLAN and the respective addresses, as well as providing the Default Gateway address, as well as preventing the first 10 addresses from being assigned. Note that G0/1 is going to obtain an address via DHCP- which is fine-īut many missed this, which caused the network to not work. The next instructions were to configure the devices so that the DNS server would work. So this essentially configured our VLANs and otherwise needed information Why? Well, we need to configure R1 to route between our VLANs, as well as creating a DHCP server for the VLANs attached to S2. To further configure VLANs, we're going to be editing our router. S2's non-trunk ports on S2 as access-ports. S2(config-if-range)#switchport mode trunk S2(config-if-range)#switchport mode access S2(config-if-range)#switchport access vlan 40 S2(config-if-range)#switchport access vlan 30 S2(config-if-range)#switchport access vlan 20 S2(config-if-range)#switchport access vlan 10 We need to configure themįor trunking, non-trunk ports as Access Ports, and other as needed.Įnter configuration commands, one per line. Our first steps, using the table above, is to create VLANs on S2 andĪssign them to the appropriate interfaces/ports. IP, DHCP relay agents, and configure a router as a DHCP client. Tutorial / Walk-through In this culminating activity, you will configure VLANs, trunks, DHCP Easy
0 kommentar(er)
